PCB for an ESP8266 device

#1

It is possible to make a DIY PCB?

Basically a breakout board for the ESP8266 to work with a normal breadboard.
It would be great if it also did all the internal connections (pin 2, 15, 0 and EN) and had peripherals for the voltage regulator, PGM/RUN pins and RX/TX interface.
Basically handles all the messy stuff so that the chip becomes plug and go (like an Arduino) for DIY home automation projects.

I’d make it myself but not that experienced with PCB making.
Purchasing the boards off you is also a way I can happily support your awesome work!!

#2

Would it also have a serial adapter?

#3

In my opinion the 5V,GND,RX,TX pins do fine.

#4

I will look into making one within the next couple months