Problem with blinds servo and openhab2

#1

I setup the whole system ,however I can control the servo with mqttfx but not with openhab. I have my devices and the control buttons and slider just as per the video, but no go.

I am using a wemos mini d1 instead of your board, is this a problem?

Any thoughts? I have gone through the setup a couple of times and no change. I have not wiped the server and started from scratch.

#2

The wemos D1 isn’t the problem, if you can set it up through MQTTfx, then it’s probably working fine. Try setting up mqtt on node red with on the pi.

#3

Found the problem. The “R” was missing from broke"R". Chair to keyboard interface issue.

Thanks for the help!